If not, please send an email to support armscor. Todd, I have a sporter stock for an 03A3 I bet would work just fine maybe someone can confirm.Got a question? Check out the section below and see if we've already got an answer for you.

From not quite finished to one that is ready to bolt a barreled action in, that is absolutely beautiful. There are a few diamonds in the rough stocks on eBay. Joined: Apr 10, Messages: 3, Location: Pennsylvania. Last edited by a moderator: Dec 23, Dec 23, 2.īefore that number on the Rock Island and under about themark on the Springfield they had problems with the receivers not being properly heat treated and were too soft and dangerous.ĭec 23, 3. I'm into it extremely cheap, no surprise there. Then decide if it's a wall hanger of potential deer slayer. My plan is to clean the cruddy bore, roll out a few light loads, tape the broken part and see if it shoots tomorrow. I can get measurements of screw holes and floor plate later. The wrist of the stock is cracked-broken and I'd like to get a replacement. Funny thing is the barrel is stamped with 'CAL. A short chat with Goofy leads me to believe it's a Springfield made my Rock Island.

The bolt handle has been lowered and it looks like a decent job of it was done. Rock Island Arsenal Model And then serial number xxx Receiver is drilled and tapped for bases. Last night I adopted a rilfle chambered in.

Rock island serial number lookup